Samsung computer won't turn on

php editor Yuzai will introduce to you the reasons and solutions for why Samsung computers cannot be turned on. When we encounter the problem that the computer cannot be turned on, it may be caused by hardware failure, software problems or improper operation. In this article, we will provide you with some common troubleshooting methods and solutions to help you quickly restore normal use of your computer. Whether you are a beginner or a user with some computer skills, you can find useful information and guidance in this article. Let’s solve the problem of Samsung computer not turning on together!

After not being used for a period of time, I cannot enter the system when I turn it on, prompting "All Boot Options are tried. Press F4 Key to Recover with factory Image using recovery or any other keys for next boot loop iteration"

■【Troubleshooting】

Boot into the BIOS and go to [SysInfo] Under the options, SATA PORT1: ST500LT012 is found, which means that the hard disk exists normally.

But there is only a network card option in the [BOOT] item, and there is no hard disk startup item.

At the same time, under the [Boot Override] option of the [EXIT] option, there is only a network card option and no hard disk startup option.

#■【Solution】

In the [EXIT] option?? Select RESTORE DEFAULTS to reset the BIOS. Can

#■【Symptom 2?】

Solution After symptom 1, the above symptoms did not appear again when I started the computer, but a blue screen appeared again, blue screen code 7B (STOP: 0x0000007B)

[Analysis]

The blue screen 7B code is typically caused by incorrect hard disk mode. The hard disk mode (SATA MODE) generally has two modes, IDE and AHCI. Some old computers It will be Compatible (compatible) and Enhanced (enhanced). New computers are basically in AHCI mode, and some will also have RAID mode.

[Cause]

If the system is installed in IDE mode and the BIOS is set to AHCI, a blue screen of 7B will occur;

At the same time, if the system is in AHCI mode If it is installed under BIOS and the BIOS setting is changed to IDE, the blue screen will be 7B.

?????? Some BIOS default to IDE, and some default to AHCI.

?????? Generally, it is recommended to use AHCI mode with solid-state drives so that the solid-state drives can be effective.

■【Solution】

Enter the [Advanced] option?? [AHCI MODE CONTROL]?? Change AUTO to Manual?? Then there will be an additional option SET AHCI MODE?? below. Adjust the back Enabled and Disabled can be used.

The above is the detailed content of Samsung computer won't turn on. For more information, please follow other related articles on the PHP Chinese website!