How to turn off overclocking on 3700x?

php editor Xiaoxin will show you the overclocking techniques of 3700x processor. As a powerful processor, AMD Ryzen 7 3700X can achieve higher frequency and performance by properly setting BIOS parameters and stable power supply. This article will introduce in detail the 3700X overclocking method, allowing you to easily improve processor performance and enjoy a smoother usage experience.

How to turn off overclocking on 3700x?

If you can enter the bios system after overclocking, you only need to enter the bios after restarting, press the button representing reset or turn off the overclocking of the CPU, confirm the restart, if it cannot be started, disconnect the power and then Find the cmos_clr/bios_clr pin on the motherboard, short-circuit it for more than 10 seconds, then connect the power and restart. Another method is to remove the battery from the motherboard, leave it for more than five minutes, then put it back, then connect the power and restart.

How to restore AMD CPU overclocking?

Press DEL or F2 (the motherboard shortcut keys are different) to enter the BIOS, select the penultimate item LOAD SAFE (load security settings) or LOAD default (load default settings) to restore The default BIOS option restores the CPU to a non-overclocked state.

If you use the motherboard jumper for overclocking, you can change the jumper cap of the motherboard FSB to the AUTO position.

How to turn off ryzen master memory overclocking?

The method to cancel overclocking is very simple, just clear the cmos and restore the bios default value.

2. Press DEL, F1, etc. to enter the bios setting interface according to the motherboard BIOS. Move the cursor to the "Load Optimized Default" item, then press Enter. Press F10 and press Enter to restart, and the CPU default frequency can be restored. .

3. Or shut down, unplug the power, find the motherboard CMOS jumper, two or three jumper pins with the word CMOS written on the PCB, insert the pin cap to position 23 and return to the original position after one to two minutes. , power on.

4. The easiest way is to take off the CMOS battery and press it in backwards. After one minute, it will return to its original state and you can turn on the phone.

How to turn off motherboard system overclocking?

To turn off the overclocking of the motherboard system, you can follow the following steps: Restart the computer and press the "Delete" key to enter the BIOS setting interface. Note that the instructions for entering the BIOS may differ depending on the motherboard model, so you need to check the motherboard manual for the correct instructions. In the BIOS setup interface, find the "AI Overclocking" or "Overclocking" option. This option is usually located below or on the right side of the main interface, but the specific location may vary depending on the BIOS version. After entering the "AI Overclocking" interface, you will see four options, namely "Auto", "Manual", "XMP" and "DOCP". Select the "Manual" option, which means manual settings. Continue in the BIOS setting interface and set the CPU frequency back to the default value. This is usually done in options such as "CPU Frequency" or "CPU Ratio". After selecting the default value, press "Enter" key to confirm. Save and exit BIOS setup. Normally, you can save and exit BIOS settings by pressing the "F10" key or the "ESC" key. After confirming the prompt, press "Enter" to confirm saving and exit. It should be noted that turning off overclocking may reduce the performance of the computer, because overclocking can improve the performance of the CPU. If you wish to remain overclocked, you can continue to use the overclocking feature. If you are not sure how to proceed, it is recommended to seek professional advice.

How to turn off the motherboard memory overclocking state?

To turn off the motherboard memory overclocking state, you need to enter the BIOS settings. The specific method is as follows:

Restart the computer.

Press the "Delete" key during startup to enter the BIOS setting interface.

Find the "AI Overclocking" option.

Press "Enter" key to enter.

In the "AI Overclocking" interface, select the "Auto" option.

Press the "F10" key to save the settings and exit the BIOS setting interface.

The above is the detailed content of How to turn off overclocking on 3700x?. For more information, please follow other related articles on the PHP Chinese website!