How does HBuilder configure the PHP environment?

Configuration method: 1. Create a php project in the www directory; 2. Install the "aptana php" plug-in; 3. Click "Run - Set up web server - External web server settings - New", edit Web server configuration; 4. Change the PHP web server to the set external server URL.

HBuilder's code prompt function is very powerful. It is definitely a good assistant for web front-end development code. It may not be the best for developing PHP files. Yes, but its built-in "view while changing mode" is definitely rare, but it still requires some configuration (code configuration), which is difficult and time-consuming. Let’s introduce it in detail below:

Prerequisites:

Create a PHP project

Here's how to create it from HBuilder:

##HBuider PHP running server configurationBecause HBuider does not integrate the PHP running environment, it depends on wampserver. In fact, HBuider is an editor, but it only needs to implement PHP code prompts and real-time automatic browser updates. It just needs to be configured.

1), select the tool——>Plug-in installation

# #2), check "aptana php" to install the plug-in.

2. Configure

Select: Run——>Set web server——>External web server settings ——>New

Browser running url: 127.0.0.1:80/php (php here is the root folder of the php project. It must be consistent with your php project in the www directory, otherwise an error will occur)

url contains the project name: choose not to include it (to avoid errors, if it is included, the following php must be removed from the above url. For smoothness, I can choose "not included").

As for the start command and stop command, there is no need to set them, and there will be no impact.

Finally "OK" to save.

Run——>Set the web server——> php class file

Click the drop-down box to select the newly built external server. Finally "OK" to save the settings.

As shown in the figure:

Next, under the php project, create the PHP file: demo.php, write the code:

<?php
phpinfo();
?>

After writing ctrl s, save it, and see if it can be done in the "View while changing mode" A page similar to the one that appeared at the beginning of the tutorial will appear.

If not, close the editor and reopen it. Or run - Chrome to see if the browser can open the phpinfo page. That’s it. Even if you open it with a browser, it can be updated automatically in real time (after the file is saved). It’s a lot easier to write.

The effect is as follows:

The above is the entire content of this article, I hope it will be helpful to everyone's study. For more exciting content, you can pay attention to the relevant tutorial columns of the PHP Chinese website! ! !

The above is the detailed content of How does HBuilder configure the PHP environment?. For more information, please follow other related articles on the PHP Chinese website!