1. If possible, add an external power supply to the USB device. An active USB hub can be used. It is also possible to connect two connectors at the same time: the USB cable of an ordinary mobile hard disk has one connector on one side and two on the other side, and one end is plugged into the hub, while the other end is fully plugged into the hub.
2. The USB port voltage can reach up to 5V. If your peripherals require a voltage higher than this data, it is recommended that the peripherals be connected to an external power supply. The USB standard interface transmission rate is 12Mbps. However, please note that a USB device can only obtain a maximum transmission bandwidth of 6Mbps. Therefore, if you want to connect an external optical drive, you can only connect it to a six-speed optical drive, and no higher.
3. You can use a three-plug USB cable. One end of the single-ended plug is plugged into the mobile hard disk, and the other double-ended plug is plugged into the two USB sockets of the computer, or one of them is plugged into the 5V mobile phone charging adapter to enhance the power supply.
4. Replace the USB data cable with the power supply head. This is a stopgap measure. After all, as I said above, it is the overall power supply that is insufficient. However, this method is the simplest and relatively cheap.
5. There are many ways to limit the power supply of each USB port to 500mA. After exceeding the limit, the interface may be automatically closed.
When the laptop is plugged in, there is no need to remove the battery. The life of a laptop battery is calculated based on the number of charges and discharges, which is generally considered to be around 500 times. Battery life is lost with use, and the number of charges and discharges must be controlled to extend battery life.
When using an external power supply for a laptop, there is no need to remove the battery. If the battery is frequently pulled in and out, it will cause some damage to the computer. How to charge a laptop: After buying a new laptop, there is no need to activate the computer. The so-called activation means continuous charging for 12 hours.
The battery can be removed when using the laptop with an external power supply. The laptop battery can be temporarily removed, but cannot be removed and left unused. Otherwise, the battery will "starve" over time. After being removed, it needs to be reinstalled once every three months, and the power consumption reaches 10% before being fully charged and continued to be used.
Can. But when the external power supply is unstable, the battery is still connected. For example, in a dormitory with many people. If you are at home, you can remove the battery and use it once every half month to a month until it prompts you to shut down or standby, then fully charge it, then remove it and store it.
When using a laptop, you need to remove the battery. For rechargeable batteries in notebooks and other devices, the charging and discharging processes must be carried out correctly in order to be used safely and maintain a normal service life. When using an external power source, the battery is fully charged. If you do not remove the battery, the battery will not recharge.
So there is no need to remove the battery when external power supply is used. However, considering that frequent charging of the battery will have a certain impact on the battery capacity, it is recommended to use the battery alone every other month until it is shut down. After repeated two or three times, the battery capacity can be restored to the maximum extent to prevent the loss of battery capacity caused by frequent charging.
There is something wrong with the power adapter. Please check whether the indicator light is on after the power adapter is connected, and please check whether the host power adapter is working properly. It is recommended to contact customer service for after-sales service and repair.
It is a problem with the power input. The power supply does not charge the 2113 battery. This is because the notebook's power management system takes protective measures to protect the battery. You can set the battery to maintain 80% power: 1. Click "Start" - "Control Panel" to open the control panel. 2. Click the "Power Options" menu.
After connecting the power adapter, the computer will detect the battery capacity. If the battery is not fully charged (or is below a certain set threshold), it will start charging the laptop. Check to see if there is battery optimization software installed in the notebook and whether there is a charging threshold setting.
There must be something wrong with your power supply, it is not charging the battery. First, check whether the power indicator light of the adapter (that is, the transformer) is on. If there is no light, you can plug it in and wait a while to test the temperature with your hands to see if it is working. If it doesn't work, it needs to be fixed.
A laptop can be used without a power source, but long-term use of a battery to power the laptop will cause damage to the laptop battery. The service life will also be greatly affected. For this reason, it is still recommended to use an external power supply when conditions permit, and as a last resort, use the battery to power the laptop.
If there is an external power supply, it is recommended to use the computer with the external power supply plugged in. If the battery is kept charged when it is fully charged, the battery will not be consumed. Therefore, if you use the computer continuously for many hours, you can always connect the external battery and unplug the power source without fully charging it.
There is no problem if the laptop is connected to an external power source for a long time. It can extend the battery life. The number of times the battery can be charged and discharged is limited. When connected to a power source, the battery cannot be fully charged or discharged. However, it is recommended to charge and discharge the battery once a month.
good. If there is an external power supply, it is recommended to use the computer with the external power supply plugged in. If the battery is kept charged when it is fully charged, the battery will not be consumed. Therefore, if you use the computer continuously for many hours, you can always connect the external battery and unplug the power source without fully charging it.
When in use, do not frequently unplug and plug in the plugs on the notebook, as the interfaces should be constantly worn. Especially when it is charged, it will damage the battery. It is recommended to turn off the phone before unplugging it. If you only use it at home, you can remove the battery and plug it directly into the power supply, which can extend the battery life.
In fact, this kind of worry is unnecessary. When a notebook is connected to an adapter, it does not use the battery (except for a very small number of high-performance notebooks with insufficient adapter power), but only charges the battery. And there is a protection mechanism after it is fully charged, so it will not continue to be charged.
1. The laptop does not need to be connected to the power supply when in use, but long-term use of the battery to power the laptop will also have a great impact on the service life of the laptop battery. For this reason, it is still recommended to use it when conditions permit. Use an external power supply when necessary, and as a last resort, use a battery to power the laptop.
2. The laptop does not need to be plugged in all the time. Laptops don’t need to be plugged in all the time. When the laptop is working, it should be plugged in at all times to reduce the loss of the battery due to excessive charging and discharging.
3. If there is an external power supply, it is recommended to use the computer with the external power supply plugged in. If the battery is kept charged when it is fully charged, the battery will not be consumed. Therefore, if you use the computer continuously for many hours, you can always connect the external battery and unplug the power source without fully charging it.
It is possible to plug the laptop into the power supply directly without the battery, and this can protect the battery to the greatest extent. Methods for preserving laptop batteries are: Before using a laptop battery for the first time, it is best to charge it for as long as possible.
Laptops can be used by removing the battery and plugging them directly into the power supply, because the external power supply can directly power the laptop.
The laptop can be used after removing the battery and plugging it in directly with the power cord. However, if the power is suddenly cut off, it will cause damage to the notebook. Laptop battery maintenance: First, the laptop battery does not need to be charged for 12 hours each time for the first three times.
Laptops can be used by removing the battery and plugging them directly into the power supply, because the external power supply can directly power the laptop. The laptop can be used after removing the battery and plugging it in directly with the power cord. However, if the power is suddenly cut off, it will cause damage to the notebook.
You can plug it directly into the power supply without installing the battery. Do not leave your computer battery unused for a long time and charge and discharge it at least once a month. If the laptop battery is not used for a long time, it is best to fully activate it three times when using it, that is, to completely replay it three times.
The above is the detailed content of Notebook external power supply. For more information, please follow other related articles on the PHP Chinese website!
![[Web front-end] Node.js quick start](https://img.php.cn/upload/course/000/000/067/662b5d34ba7c0227.png)
