It may be caused by the following reasons:
1. Power supply problem: Check whether the power cord is plugged in tightly and whether the power supply is stable;
2. Hardware failure: It may be If there is a problem with the motherboard itself or other hardware, it is recommended to check whether the memory module, graphics card, CPU, etc. are working normally;
3. Software conflict: Some software may be incompatible with the motherboard. It is recommended to upgrade or replace with the latest version;
4. Operating system problems: It may be that the operating system is abnormal. It is recommended to reinstall or repair the operating system;
5. Overheating problem: Check whether the cooling system is working normally, such as whether the fan rotates normally and dissipates heat. Are the tablets clean? If the above methods are ineffective, it is recommended to contact after-sales service or professional technicians for further investigation and repair.
Cyclic restarting of the Gigabyte motherboard should be a BIOS problem. The solution is as follows:
When the computer is turned off, press and hold the power button for ten seconds, then release the button, and press the power button to turn on the computer. You will experience After two short reboots, the third time the screen will be displayed and recovery will begin.
Then it will enter a state where the CMOS has no data, and you will be prompted to set up the BIOS when booting. Flash the BIOS.
After flashing the BIOS, take out the battery, cut off the power, discharge it, and leave it alone. Test whether the BIOS is as prone to failure as the previously restored BIOS. If there is no problem, you can turn it on.
1. There may be incompatibilities between systems or programs. Press F8 after booting until the advanced options appear, then let go. Select "Last Known Good Configuration" and press Enter to fix it. If it still doesn't work, press F8 to enter security. Restore the system or reinstall the system.
2. Caused by excessive temperature of CPU or other hardware, incompatibility or failure of memory and graphics card.
3. The hard disk has bad sectors. Please use the system's built-in functions or software to repair the disk, or format the hard disk, repartition the system, and reinstall the system.
4. Power failure and voltage instability can also cause automatic restart.
5. Driver incompatibility can also cause restarting.
6. Mainboard component failure.
7. Change the system's default automatic restart: right-click My Computer/Properties/Advanced/Startup and Recovery Settings/uncheck "Automatic Restart" in System Failure, and then press OK and the application to restart your computer.
The dual BIOS design of GIGABYTE motherboards is to provide higher system stability and reliability. When there is a problem with the primary BIOS, the backup BIOS will automatically take over to ensure the normal operation of the system. However, if your GIGABYTE motherboard encounters dual BIOS infinite reboots during use, there may be several reasons:
1. BIOS settings are incorrect: First, make sure your BIOS settings are correct. Sometimes, incorrect settings can cause the system to fail to boot properly and enter an infinite reboot loop. You can try restoring the BIOS to default settings, or reconfigure the BIOS to suit your hardware and operating system.
2. BIOS update problem: If you have recently updated the BIOS version, there may be compatibility issues or errors during the update process. It is recommended that you try to roll back to the previous BIOS version, or contact GIGABYTE customer service for support and solutions.
3. Hardware failure: Another possible cause is hardware failure. For example, there may be problems with hardware components such as the CPU, memory module, and graphics card, causing the system to fail to start normally. You can try troubleshooting, inspecting and replacing hardware components one by one to determine the source of the problem.
4. Power supply problem: Unstable power supply may also cause the system to fail to start normally and enter a reboot cycle. Please ensure that your power supply meets the motherboard's requirements and can provide sufficient power stability.
If you have tried the above methods and still cannot solve the problem, we recommend that you contact GIGABYTE customer service or professional computer repair personnel for further diagnosis and repair.
I have also encountered this problem. You first unplug the main power plug, then plug it in, then press and hold the power button for one minute (don’t let go no matter what happens to the computer), then let go. After a few seconds, press the power button again and the following interface should appear. After the progress bar runs out, just choose to load the default settings and restart. (This is my answer in another place)
1. The computer automatically restarts. Sixty percent of the time it is caused by a problem with the power supply, which is caused by leakage of the large capacitor of the power supply and insufficient power supply. This can be solved by replacing the power supply. 2. Motherboard If there is a problem with poor contact between the memory slot and the memory, you can pull out your current memory, and then use an eraser to rub the area where the gold finger is (that is, where the copper piece is) and rub it back and forth a few times. , blow off the ashes, and then plug it back in or change a memory slot and plug it back in. (Of course, if the memory integrated block has a weak solder, it will always restart). 3. There is something wrong with your CPU fan or heat dissipation. The clamp of the device is loose. When the CPU fan is stuck, the CPU cannot cool down. When the temperature reaches the set temperature of the motherboard, the motherboard starts protection and automatically restarts. So you only need to replace the fan, or the fan is blocked by dust. Just unplug the fan and the radiator clip is loose. The principle is the same as above. Just reinstall it and add some silicone grease to the CPU. This is all to cool down the CPU. As long as the CPU can ensure normal usage temperature, automatic restart will not occur. 4. There is a weak solder in the video memory integrated block of the graphics card, which causes poor contact with the motherboard after powering on, and it will automatically restart. The solution is: add soldering to the video memory, or replace the graphics card. 5. Replace the hardware on the motherboard one by one. Check, if there is indeed a problem with the motherboard, you can contact the seller or after-sales personnel for inspection and repair
The above is the detailed content of Gigabyte motherboard b760 freezes on startup and automatically restarts?. For more information, please follow other related articles on the PHP Chinese website!
![[Web front-end] Node.js quick start](https://img.php.cn/upload/course/000/000/067/662b5d34ba7c0227.png)
