What to do if 0x00000f4 blue screen occurs

## Computer blue screen problem is one of the most common computer problems. Most of the time, the blue screen failure is related to software. A few are caused by hardware incompatibility or failure. Here is a rough analysis of the problem with the STOP:0x000000F4 field, for reference only! Let’s first take a look at how netizens analyze and solve the problem!

Cause analysis of blue screen code 0x000000f4:

If you know the reason, it will be easy to solve similar problems.

1. Start with the soft side first. If running the software causes an error, it is recommended to reinstall the software, which can usually solve the problem.

2. Consider whether there are other software running at the same time causing conflicts or the host configuration memory is too small, causing memory overflow or exhaustion (for example, if the XP system is used, it is recommended to configure 512MB of memory or more or 512MB)

3 .Check whether the relevant driver or BIOS has been reinstalled or upgraded recently, then it may be caused by driver incompatibility. Just uninstall and reinstall the original driver

4. If the first three points are excluded, we can basically tell you, Unfortunately! It's probably a hardware issue. To determine whether it is a hardware failure, it is recommended to format the hard disk, reinstall the system, see if it is normal, and rule out viruses and system-related failures!

5. Hardware problems, as I explained above, mainly check the memory and check whether the memory metal strips are oxidized. If more than two memory strips are installed, remove one or change the memory slot. Other motherboards, power supplies, heat dissipation, etc. will not be introduced one by one!

Blue screen code 0x000000f4 Troubleshooting:

Netizen 1:

stop:OX000000F4

Blue screen code Tip: Memory access error

Recommended method by netizens: This phenomenon is caused by the memory stick being used for too long. The gold finger of the memory stick is actually made of copper. Over time, the surface will oxidize, resulting in poor contact. You can open the case, pull out the memory module, wipe the gold finger with an eraser, and then reinstall it.

Netizen 2:

STOP:0x000000F4 Memory access error This type of string represents the memory address:

Netizen recommended method: memory stick It may be enough to unplug it and wipe it and change the slot. You can also wipe it with rubber and then insert it again!!!

Netizen 3:

STOP:0x000000F4 (0x00000003, 0x81E95460, 0x81E955D4, 0x805FB7A8) refers to a memory error. I don’t know the specific data behind it. It should refer to a certain block.

Error analysis: The kernel layer detects an interrupt storm in the system, such as: a certain device The occupied interrupt is not released after completing the operation. This is usually caused by a defective driver.

That number is the memory address. You can try it. Pull out the memory and install it again. My computer This problem has occurred before, and it was solved after replacing the memory. Some games are incompatible with your graphics card driver. You can upgrade the graphics card driver. (Upgrade or uninstall the latest installed hardware driver)

Tips:

It is best to reinstall the system first. If you have problems with certain software, then you should not use it. Check to see if other software has this problem. , (This is done after you reinstall the system)

Netizen 4:

STOP: 0x000000F4 means: memory access error, that number is memory Address, is this problem a recent issue or has it been since ghost? If it has been a recent issue, just ghost it again. If it has been a problem since ghost, it is recommended that you install it again in the current partition state. .

---

Warm reminder: Regarding the above four methods recommended by netizens to solve the blue screen code 0x000000f4, you can learn from them. Different computer blue screen faults use different solutions. I hope it can help. Let's solve computer problems!

For more related knowledge, please visit theFAQcolumn!