How to remove mac address filtering

Mac address filtering is a common network security measure that allows network administrators to set up a router or switch so that only the Mac address of a specific device can access the network. However, sometimes we may encounter situations where we need to unblock Mac address filtering, such as when we purchase a new device or replace network hardware.

There are two main ways to remove Mac address filtering: remove or reset the network device through the network device management interface.

1. Unblock Mac address filtering through the network device management interface:

First, we need to know the IP address of the network device and make sure it is connected to the same LAN. Then, open the browser and enter the IP address of the device to enter the management interface of the network device.

Next, enter the correct username and password to log in to the management interface. Typically, this information can be found on the back of the device or in the user manual. After logging in, find the Mac address filtering settings in settings or security options.

On the Mac address filtering settings page, you can see the list of Mac addresses that have been added. Find the Mac address of the device you want to unfilter and check the corresponding checkbox. Then, click the Remove or Disable button to remove them from the list.

Finally, save the changes and restart the network device. Now that the Mac address filtering has been lifted, the device can be reconnected to the network and accessed normally.

2. Reset network device:

If you cannot unblock the Mac address filtering through the management interface, or you have forgotten the administrator password of the device, you can try to use the reset button Reset network devices.

First, find the reset button on the back of the device. This button may need to be pressed with a small tool, such as a pen tip or a toothpick. Before pressing the button, make sure the network device is powered off.

Next, use a pen tip or toothpick or other tool to press and hold the reset button for more than 10 seconds. This time may vary depending on your device model, please refer to your device's user manual.

After completing the reset operation, wait for the network device to restart, and then reconfigure the network device, including WiFi settings, passwords, etc.

Although the method of resetting network devices is relatively simple, it requires reconfiguring all network settings. Therefore, it is recommended to back up and record the original network device configuration before proceeding.

To sum up, removing Mac address filtering can be achieved by removing or resetting the network device through the network device management interface. Choosing the right method depends on the situation, and whichever method is used requires caution and ensuring a good understanding of the network equipment.

The above is the detailed content of How to remove mac address filtering. For more information, please follow other related articles on the PHP Chinese website!