Home>Article> How to check the ip address of wsl2

How to check the ip address of wsl2

DDD
DDD Original
2024-08-14 16:03:19 947browse

This article provides instructions on how to check, change, and verify the IP address assigned to Windows Subsystem for Linux 2 (WSL2). The focus is on obtaining the IP address using the "ifconfig" command, editing the network configuration

How to check the ip address of wsl2

How to Check the IP Address of WSL2

To check the IP address of WSL2, open a command prompt in WSL2 and run the following command:

ifconfig eth0

The IP address will be displayed in the output of the command.

How to Change the IP Address of WSL2

To change the IP address of WSL2, you need to edit the network configuration file. The steps to do this are as follows:

  1. Open the network configuration file in a text editor. The location of the file is:
/etc/wsl.conf
  1. Find the line that starts with[network], and add the following lines to the file:[network], and add the following lines to the file:
[network] interface = eth0 address = 192.168.1.100 netmask = 255.255.255.0 gateway = 192.168.1.1
  1. Replace the IP address, netmask, and gateway with the desired values.
  2. Save the file and close the text editor.
  3. Restart WSL2 by running the following command:
wsl --shutdown

How to Determine Whether WSL2 Has Been Assigned an IP Address

To determine whether WSL2 has been assigned an IP address, open a command prompt in WSL2 and run the following command:

ip addr show eth0

If WSL2 has been assigned an IP address, the output of the command will include a line that starts withinet

rrreee
    Replace the IP address, netmask, and gateway with the desired values.Save the file and close the text editor.Restart WSL2 by running the following command:rrreeeHow to Determine Whether WSL2 Has Been Assigned an IP AddressTo determine whether WSL2 has been assigned an IP address, open a command prompt in WSL2 and run the following command:rrreeeIf WSL2 has been assigned an IP address, the output of the command will include a line that starts with inet.

The above is the detailed content of How to check the ip address of wsl2. For more information, please follow other related articles on the PHP Chinese website!

Statement:
The content of this article is voluntarily contributed by netizens, and the copyright belongs to the original author. This site does not assume corresponding legal responsibility. If you find any content suspected of plagiarism or infringement, please contact admin@php.cn
Previous article:How to activate xmind Next article:How to activate xmind