php 启动报错的解决方法

php 启动报错的解决办法
php 启动时报错的情况，如下：

[[email protected] lnmp]# service php-fpm start Starting php-fpm eAccelerator: Could not allocate 67108864 bytes, the maximum size the kernel allows is 33554432 bytes. Lower the amount of memory request or increase the limit in /proc/sys/kernel/shmmax. [04-Dec-2013 19:06:44] NOTICE: PHP message: PHP Warning: [eAccelerator] Can not create shared memory area in Unknown on line 0 www.jbxue.com[04-Dec-2013 19:06:44] NOTICE: PHP message: PHP Fatal error: Unable to start eAccelerator module in Unknown on line 0 failed 

解决方法：

[[email protected] lnmp]# vi /etc/sysctl.conf # Kernel sysctl configuration file for Red Hat Linux # # For binary values, 0 is disabled, 1 is enabled. See sysctl(8) and # sysctl.conf(5) for more details. # Controls IP packet forwarding net.ipv4.ip_forward = 0 # Controls source route verification net.ipv4.conf.default.rp_filter = 1 # Do not accept source routing net.ipv4.conf.default.accept_source_route = 0 # Controls the System Request debugging functionality of the kernel kernel.sysrq = 0 # Controls whether core dumps will append the PID to the core filename. # Useful for debugging multi-threaded applications. kernel.core_uses_pid = 1 # Controls the use of TCP syncookies net.ipv4.tcp_syncookies = 1 # Disable netfilter on bridges. net.bridge.bridge-nf-call-ip6tables = 0 net.bridge.bridge-nf-call-iptables = 0 net.bridge.bridge-nf-call-arptables = 0 fs.file-max=65535 net.ipv4.tcp_max_syn_backlog = 65536 net.core.netdev_max_backlog = 32768 net.core.somaxconn = 32768 net.core.wmem_default = 8388608 net.core.rmem_default = 8388608 net.core.rmem_max = 16777216 net.core.wmem_max = 16777216 net.ipv4.tcp_timestamps = 0 net.ipv4.tcp_synack_retries = 2 net.ipv4.tcp_syn_retries = 2 net.ipv4.tcp_tw_recycle = 1 #net.ipv4.tcp_tw_len = 1 net.ipv4.tcp_tw_reuse = 1 net.ipv4.tcp_mem = 94500000 915000000 927000000 net.ipv4.tcp_max_orphans = 3276800 # TIME_OUT后等待时间 #net.ipv4.tcp_fin_timeout = 30 #net.ipv4.tcp_keepalive_time = 120 net.ipv4.ip_local_port_range = 1024 65535 kernel.shmmax = 128000000 

加上最后一句话 kernel.shmmax = 128000000
然后应用sysctl -p

[[email protected] lnmp]# service php-fpm start Starting php-fpm done [[email protected] lnmp]# /usr/bin/memcachedstart